Kontakt

Vi ger personlig service från måndag till fredag, från 8:00 till 17:00. Via den här länken hittar du kontaktpersonen för din region.

Huvudkontor Wolfurt
+43 5574 6706-0

Din kontaktperson

SHOP

Varukorg {{ (warenkorbCtrl.warenkorb.bestellNummer ? (' [' + warenkorbCtrl.warenkorb.bestellNummer + '] ') : '' )}} | {{warenkorbCtrl.warenkorb.items.length}} Artikel Ändra varukorg

Anmärkning

Bild

Artikel

Enhetspris

Totalpris

Totalt pris inklusive rabatt

{{warenkorbItem.bezeichnung | artikelBezFilter:warenkorbItem.attributwertEingaben:[{attrPrefix: 'L_', searchPattern: '/...', replacePrefix: '/', replaceSuffix: ''}] }} {{warenkorbItem.bezeichnung | artikelBezFilter:warenkorbItem.attributwertEingaben}}

{{attributwertEingabe.attributBezeichnung}}

{{hannexItem.Bezeichnung}}

Logga in för att se dina priser och fortsätta med beställningen.

I vårt stora sortiment finns lämpligt material för nästan alla användningsfall.

1.2344 / 1.2344 ESU Hot-work steel

Designation

DIN:	X 40 CrMoV 5-1
AFNOR:	Z 40 CDV 5
UNI:	X 40 CrMoV 5-1 KU
AISI:	H13 / H13 ESR

Chemical composition:

C	0.40
Si	1.00
Cr	5.30
Mo	1.40
V	1.00

STRENGTH:

max. 230 HB
(≈ max. 780 N/mm²)

Thermal conductivity at 100 °C: 26 W/m K

Character:

high-alloy hot-work steel, high heat resistance, high wear resistance, good toughness, thermal conductivity and hot cracks resistance, limited use for water cooling; for very high requirements available in grade *ESR (Electro-Slag Remelted)

Application:

standard material for hot-work tools, extrusion moulds, dies, tools for plastic processing

Treatment by

Polishing, etching, EDM, nitriding » is possible
Hard chroming » in special cases

Heat treatment:

Soft annealing:
750 to 800 °C for about 4 to 5 hours; slow controlled cooling of 10 to 20 °C per hour to about 600 °C; further cooling in air, max. 230 HB

Hardening:
1020 to 1060 °C
15 to 30 minutes keeping curing temperature
quenching in water/oil
obtainable hardness: 54 HRC

Tempering:
slow heating to tempering temperature immediately after hardening; minimum time in furnace: 1 hour per 20 mm part thickness

Technical tip:

susceptible to corrosion; during machining, continuous corrosion protection has to be ensured (especially during wire EDM)
1.2344 ESRH is very suitable for mirror polishing